Digi One IAP combines reliable serial-to-Ethernet connectivity with
protocol conversion and interoperability. Users can IP enable a broad
range of serial devices, as well as link two industrial devices. It is
ideal for device management and monitoring applications requiring
specific industry protocol support.
Serial server functionality built into Digi One IAP allows virtually
any serial device to be connected to a TCP/IP network. Applications may
communicate with the serial device using TCP/UDP or Digi’s patented
RealPort® COM port redirector for remote native COM port access.
RealPort enables existing applications to communicate, without
modification, with serial devices over the Ethernet. By creating a
Modbus bridge multiple Modbus/TCP masters can share Modbus serial slaves
or Modbus serial Masters can access Modbus/TCP slaves.
Digi One IAP supports a variety of serial (DF1, Modbus, ASCII) and
Ethernet (ModbusTCP, AB/Ethernet, Ethernet/IP) protocols, allowing users
to bridge serial and Ethernet devices, or both. Multi-master access
allows multiple masters to communicate with a single slave across
protocols. Digi One IAP converts ASCII data from serial devices to
Ethernet protocols. An additional serial port can act as a pass-through
port, allowing local devices to communicate with a slave unit without
disrupting the serial-to-Ethernet connection.
- Industrial protocol conversion and interoperability
- 1 DB-9 serial port and additional pass-through port
- Multi-master/multi-protocol support
- Switch selectable RS-232/422/485
- Tunable for low latency or optimized throughput